Before Use
04
Speaker Connections
Caution:
To avoid damaging the speakers with a sudden high-level
signal, be sure to switch the power off before connecting
the speakers.
< Check the impedance of your speakers.
Connect speaker with an impedance of 8 ohms or more.
The amplifier's red speaker terminals are the +
(positive) terminals and the black terminals are the _
(negative) terminals.
<
The
+ side of the speaker cable is marked to make it
distinguishable from the _ side of the cable. Connect
this marked side to the red+ terminal and the unmarked
side to the black terminal.
< Prepare the speaker cords for connection by stripping
off approximately 10 mm or less (no more as this could
cause a short-circuit) of the outer insulation.
Twist the wires tightly together so that they are not
straggly :
How to connect
Press the lever, insert the stripped and twisted end
(approx. 3/8") of the cord, then release the lever :
Make sure it is fastened securely by pulling the cord
lightly.
CAUTION
Turn off the power of all the equipment before making
connections.
Read instructions of each component you intend to use
with this unit.
< Be sure to insert each plug securely. To prevent hum
and noise, do not bundle the connection cords with the
power cord or speaker cord.
Read this before operation
< Choose the installation location of your unit carefully.
Avoid placing it in direct sunlight or close to a source of
heat. Also avoid locations subject to vibrations and
excessive dust, heat, cold or moisture.
< The ventilation holes should not be covered. Make sure
there is enough space above and beside the
amplifier/receiver (about 4 inches). Do not place a CD
player or other equipment on top of the amplifier/receiver.
< Do not open the cabinet as this might result in damage to
the circuitry or electrical shock. If a foreign object should
get into the set, contact your dealer.
< When removing the power plug from the wall outlet,
always pull directly on the plug, never yank the cord.
< Do not attempt to clean the unit with chemical solvents
as this might damage the finish. Use a clean, dry cloth.
< Keep this manual in a safe place for future reference.
Back-up Memory Function
This is the function which preserves the preset memory and
most-recent memory functions. In the event of a power
failure, or if the power cord of this unit is disconnected from
the electric outlet, the back-up memory will preserve the
preset memory and most-recent memory functions for as
long as approximately 3 days.
If the power supply is interrupted for 3 days or longer, the
memory settings will be erased.
When to Use RESET Switch
< When this system is subjected to an electrical shock.
< When the power is irregular.
In these cases, try the following
Press the TUNING MODE button for more than 5 seconds.
Note:
If the TUNING MODE button is pressed for more than 5
seconds Standby mode, all the memory will be erased.
Read this before operation Before Connection
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern